How do I install the photocell in my stainless steel transformer?

Integral Lighting

Answer
  1. Make sure your power is OFF and the transformer is NOT plugged into an electrical outlet. *No splice or wiring is required if the transformer is equipped with a jumper connector.
  2. Open the front cover of your transformer housing by lifting the cover UP.
  3. Locate and disconnect the white jumper connector inside the housing. *Save the jumper connector with these instructions for possible future use.
  4. Remove one of the 7/8″ diameter knockouts on the side of the transformer and push the photocell white connector through the knockout hole.
  5. Inside the housing, slide the spacer and the star nut over the white connector and thread onto the photocell and tighten.
  6. Plug the photocell white connector into the housing connector.
  7. Push the front cover back into position and secure with the two screws provided.
  8. Locate the transformer and position the photocell so that no artificial light will shine on the cell. This would cause the photocell to cycle on and off.
  9. Plug the transformer cord into a standard 115/120 volt receptacle. *The transformer cord MUST be plugged into a weather-tight receptacle equipped with a Ground Fault Circuit Interrupter (GFCI).